Checking the Signal Lead

Checking The Signal Lead












Take a resistance reading between
- 3 - Tilt sensor
- 19 - Control module, TWICE

The reading should be 0 Ohm - 1 Ohm

Checking the wiring harness.
Jiggle the leads and in-line connectors at several places and in different directions to reveal intermittent breaks and short circuits in the wiring harness. Observe the multimeter test lamp or diagnostic tool while doing this.

Is the function correct ?

NO - Rectifying the Lead - II

YES - Checking the Sensor's Signal Lead For Shorting to B+