Removal and Replacement

Washer Fluid Reservoir

To Remove





1 Drain the washer fluid from the reservoir.
2 Raise the car.
3 Remove the two retaining screws on the front of the wing liner.
4 Pull out the two pumps and the level sensor from the reservoir and let them hang on their hoses and leads.
5 Remove the 3 reservoir retaining screws and pull the washer fluid reservoir straight down.

To Fit





1 Place the reservoir in its correct position and fit the retaining screws.
2 Fit the pumps.
3 Fit the level sensor with its float downwards
4 Fit the wing liner with two retaining screws.
5 Lower the car.
6 Fill the reservoir with washer fluid.