Diagram Information and Instructions

Components
16 Rheostat for instrument lighting: in lighting switch panel between steering wheel and driver's door.
22a Fuse box: on short side of instrument panel by driver's door.
40FL Horn: behind left-hand side of front grille.
40FR Horn: behind right-hand side of front grille.
41 Horn connector: on steering wheel
68 Horn relay: in engine bay on main relay board.
195 Washer fluid level switch: on washer fluid reservoir in front left wheel housing.
228b Filament monitor for front lamps: on main relay board in engine bay.
242 Coolant level switch: in expansion tank.
286 Outside temperature sensor: in centre of front spoiler.
336b Connector unit for horn/switch: in steering wheel.
342a Main fuse box: Behind battery.
540 Main instrument unit: In dashboard in front of driver.
541 SID: in centre of dashboard.
544 Information lamp, INFO DISPL: in main instrument unit.
633 Steering wheel switch unit: on steering wheel rim.

43-pin connector
H43-1 White connector on connector bracket below left A-pillar.

Crimp connections
J3 Front wiring harness: approx. 100 mm from grounding point G30 branching point towards ABS control module.
J6 Front wiring harness: in main fuse box in engine bay approx. 20 mm from the branch to the relays.
J40 Instrument wiring harness: approx. 100 mm
LHD from DICE branching point towards connector H43-1.
J40 Instrument wiring harness: approx. 40 mm
RHD from DICE branching point towards engine bay grommet.
J41 Instrument wiring harness: approx. 200 mm
LHD from SID branching point towards MIU.
J41 Instrument wiring harness: approx. 20 mm
RHD from warning switch branching point towards MIU.
J58 Instrument wring harness: approx. 50 mm
LHD from MIU branching point (12-pin connector) towards data link connector.
J58 Instrument wiring harness: approx. 180 mm
RHD from MIU branching point (12-pin connector) towards heater housing.
J66 Instrument wiring harness: approx. 30 mm
LHD from steering wheel switch branching point towards DICE.
J66 Instrument wiring harness: approx. 100 mm
RHD from MIU branching point (20-pin connector) to DICE.
J72 Instrument wiring harness: approx. 50 mm from MIU 12-pin connector.
J73 Instrument wiring harness: approx. 50 mm from MIU 12-pin connector.
J76 Instrument wiring harness: approx. 50 mm from SID connector.
J77 Instrument wiring harness: approx. 50 mm from SID connector.

Grounding points
G2 On left structural member behind headlamp.
G30 On side panel in front of left-hand wheel housing.
G40 In cabin on left-hand side of knee protection bar.
G41S Centre ground bolt in middle of knee protection bar (in cabin).