Fan Motor, Seat

To remove







1 Raise the front seat and remove it from the car
2 Remove the PSM control module from the bracket, 2 screws.
3 Remove the bracket for the PSM control module by cutting the cable tie.
Unplug the 29-pin connector from the bracket.
4 Unplug the connector and cut the cable ties.
5 Remove the 2 nuts holding the fan motor.







6 Unplug the connector to the fan motor and cut the cable ties.
Lift out the motor.

To fit







1 Refit the fan motor, 2 nuts.
2 Plug in the connector for the fan motor and fasten the wires with cable ties.
3 Replace the 29-pin connector on the bracket and reattach the bracket with cable tie







4 Plug in the connector and secure the wires with cable ties.
5 Screw the PSM control module to the bracket, 2 screws.
6 Replace the front seat.