Armrest Upholstery, Rear Seat 5D

To remove







1 Lower the armrest and detach the upholstery tab from the edge of the plate. Remove the four nuts and lift off the armrest.
2 Remove the blank washer or cup holder if fitted.
Remove the cup holder by pressing it out half way. Bend the lock tabs out of the way with a screwdriver while pulling the cup holder out of the armrest.
3 Loosen the Velcro fastening







4 Cut oft the clips holding the upholstery to the cushion and pull of the upholstery.

To fit







1 Fit the armrest upholstery, make sure it is in the correct position.
2 Fit the clips with the pliers included with fitting kit 84 71 O62.
3 Close the Velcro fastener.
4 Press in the blank washer or cup holder.







5 Fit the armrest to the rear seat backrest with the 4 nuts and fasten the upholstery tab to the edge of the plate.
Raise the armrest.