A. Damper Mat

1. Dismantle the rear seat cushions and backrest. See WIS; 8 Interior equipment, Seats, Cushions, rear seat and Backrest, rear seat.

2. Remove the scuff plates on both sides. Start by lifting the rear edge.





3. Remove the two outer seat belt mountings and left hand seat belt buckle.

4. Undo the clips securing the rear edge of the carpet. Use special tool no. 84 71 179.

5. Fold forward the carpet.

Note:
Fold along the line of the seat hinges.





6. Lay out the damper mat and press down at the hinges. Lay the mat under the luggage compartment carpet.

WARNING:
It is essential that the hooks for the anti-submarining protection protrude from the punched holes in the mat as they must grip the seat cushions in the event of a collision.





7. Re-lay the carpet and fit the clips on the rear, pressing them through the damper mat.

8. Fit the scuff plates.

9. Fit the seat belt mountings and buckles. Tightening torque: 45 Nm (33 lbf ft).

Note:
Buckle the seat belts and make sure they were not twisted when fitting.

10. Fit backrest and cushions. See WIS; 8 Interior equipment, Seats, Seat cushion, rear seat and Backrest, rear seat.