Clutch Housing

Replacement Of Bearing Race Input Shaft
To Remove





1. Press out the bearing race with sleeve 87 91 204 with tool 87 92 236 as support.


To Fit





1. Seat the bearing race using a plastic hammer.
2. Press on the bearing until it stops with drift 83 90 312 Sleeve 83 90 114 and sleeve 87 91 311 must be used.


Replacement Of Bearing Bushing For Selector Rod
To Remove
The seal ring must have been removed first.





1. Drive out the bearing bushing with drift 87 91 220.


To Fit





1. New bearing bushing is fitted with drift 87 91 220.

Differential Bearing Race In Clutch Housing
To Remove





1. Carefully tap out the bearing race with a hammer and a drift (destructive removal)

IMPORTANT: Tap the same amount on both sides!


To Fit





1. Fit (press) in the new bearing race until it stops with drift 83 90 122 and sleeve 87 91 204.





2. Fit a new seal with drip 83 90 122