Input Shaft Speed Sensor (532)

Input Shaft Speed Sensor

To Remove
1. Put the expansion tank out of the way.





2. Remove the sensor's screw.
3. Raise the car.
4. Remove the front left wheel.
5. Remove the sensor.
6. Unplug the connector.

To Fit





1. Plug in the sensor and position it in place.
2. Put back the front wheel.
Tightening torque: 110 Nm (81 ft. lbs.)

3. Lower the car to the floor.
4. Tighten the sensor's retaining bolt.
Tightening torque: 6 Nm (4.5 ft. lbs.).

5. Put back the expansion tank.