Procedure

Replace the shift lock solenoid using the following procedure.





1. Remove the gear selector lever housing.

Important
When working with a dismantled selector lever housing, be sure to protect it from damage by laying it on a soft surface, such as a clean shop rag or a piece of foam rubber.

2. Cut the table ties.

3. Remove the pins for the solenoid from the connector (pins 5 and 6 in the 6-pin connector and pin 2 in the 2-pin connector).





Note
Note the location of the 3 pins in the connector.

4. Drill out the rivets using a 3 mm drill bit.

5. Separate the upper and lower parts of the selector lever housing slightly at the front. Undo the screws on the solenoid.

6. Undo the lever on top of the solenoid and remove the solenoid.





To fit

1. Fit the solenoid to the lever.

2. Fit the solenoid's two screws.

3. Fit the two parts of the selector lever housing together.

4. Rivet the parts of the selector lever housing together.

5. Connect the leads on the solenoid.

6. Secure the leads with a cable tie.

7. Fit the selector lever housing.