Oxygen Sensor 2

To remove







1 Remove the engine cover.
2 Unplug the sensor cable.
3 Note the position of the cable and any cable ties before detaching the cable. The cables must not be twisted together.
4 Raise the car and remove the oxygen sensor.

To fit


IMPORTANT
The oxygen sensor threads must be coated with Molycote 1000 or equivalent before fitting.







1 Fit the oxygen sensor.
Tightening torque: 55 Nm (40 lbf ft)
2 Lower the car and mount the cables (must not be twisted).
3 Plug in the connector
4 Fit the engine cover.