Inside Front Door Window Seal - Comes Loose
SI No. 844-1784PI No.
Date September 1997
Distr. all
900
Correcting Complaint that Internal Front Door Window Seal is Coming Loose
Background
The internal window seal on some cars can lift up a few mm at the rear edge. Follow the directions to rectify this complaint.
Parts
Screw (2): 7975535 (CA: 30509241)
Action
1. Push down the door strip to the correction position. Remove the door panel.
2. Lower the window.
3. Protect the window from drilling damage by putting a putty knife (or something similar) between the internal window seal and the window.
4. Drill a 2 mm hole approximately 10 mm (on 3-door) or approximately 55 mm (for convertible) from the rear of the internal window seal. See Figure.
Drill through the seal and flange. See Figure.
5. Fit the screw, P/N 79 75 535, in the hole (See Figure).
6. Refit the door panel.
Warranty/time Information
To resolve a customer complaint for a vehicle in warranty, submit a claim using the information shown.
Failed object: 84422
Fault/reason: 07
Location: 3/4/5
Warranty type (US): 01
Repair/action: 05
Labor operation/time: 84422 0.2
CA: Left side B7876 0.2, right side B7866 0.2