Programming

Starting with M 1995, the Intelligent Saab Tester (ISAT) Scan Tool is equipped for programming Saab Information Display (SID) 213 and SID 4 (SID 1 with audio display). Only one basic programming routine is provided and since the ISAT Scan Tool does not show how the instrument is programmed, the routine cannot therefore be used to check this. Basic setting of the following features is carried out and they must be adapted to the relevant market by means of the adjustment commands.

- Service indicator
The normal service interval is 20,000 km. This can be programmed and changed with "SERVICE INDICATOR" in the ADJUSTMENT" menu.

- Language
The basic setting (English) can be changed with "LANGUAGE" in the "ADJUSTMENT" menu.

- Units
The basic setting (metric) can be changed by means of the SID unit's pushbuttons.

- Speed warning ME
This speed warning feature is inactive in the basic setting. It is activated by "SPEED WARNING ME" in the "ADJUSTMENT" menu.


NOTE: It is advisable before programming is started to make a note of the current equipment of the SID version (Sensonic, TSAS or
standard). These details are required in connection with programming.


SCAN TOOL DISPLAY 1

SAAB INFO DISPLAY
ADJUSTMENT
=>PROGRAMMING
READ SYSTEM INFO

1 Select PROGRAMMING in the ISAT Scan Tool's SAAB INFO DISPLAY program.


SCAN TOOL DISPLAY 2

PROGRAMMING OF A
NEW SID UNIT
F1 = CONTINUE
ESC = END

2 Continue to the programming phase or terminate.


SCAN TOOL DISPLAY 3

SELECT TYPE OF
SID UNIT
SID 2/3
SELECT

3 State the SID type in question, which may be SID 2/3 or SID 4. (SID 4 = SID 1 with audio display)



SCAN TOOL DISPLAY 4


SELECT EQUIPMENT
XXX
SELECT

4 State equipment, which may be ACS (Sensonic), HOOD (TSAS), ACS/HOOD or NORMAL


SCAN TOOL DISPLAY 5

PROGRAMMING WILL
NOW OCCUR!!
F1 = OK
ESC = END

5 Program the instrument with the entered details.


Important: Both these commands will cause the instrument to be programmed. This will be corrected for M1996.


SCAN TOOL DISPLAY 6

PROGRAMMING
CARRIED OUT

6 This menu confirms that programming has been carried out.


SCAN TOOL DISPLAY 7

PROGRAMMING
INTERRUPTED

7 This menu is displayed if programming has been interrupted with ESC.