Electronic Brake Control Module: Testing and Inspection

Main Connector View:

Pins 1-21:

Pins 22-26:

Remember:
- Measurements should be taken directly from the electronic control module sensor connector. Remove the electronic control module connector.
- A few voltage levels must be seen as standard value. Use sound reasoning when judging whether a measured reading is correct or not.
- If any measurement value is incorrect, use the wiring diagram to find which conductor, connector or component requires further testing.
- The side references on the table refer partly to the particular signals and partly to the fault diagnosis with a complete description of rectification procedures.
- If nothing else is indicated the ignition timing should be disconnected.
- The test reading given concerns calibrated FLUKE 88/97.

NOTE: There is no BOB cable to ABS 5.3.