Programming For Remote Control

The remote control that is used for the car's anti- theft alarm must be programmed (coded) for that particular car. When the car is delivered, 2 preprogrammed remote control units are supplied. It is also possible to program 2 additional remote control units (a total of 4 remote control units can be programmed) for the car.

Programming
One remote control
1 Connect an Intelligent Saab Tester (ISAT) scan tool.
Select "PROGRAMMING".
2 Select "REMOTE CONTROL".
Select "PROGRAMMING".
3 Point the remote control at the aerial and press one of the buttons within 5 seconds of selecting the ISAT scan tool command.

Deprogramming a remote control
1 Select "REMOTE CONTROL".
Select "DEPROGRAMMING".
2 Point the remote control at the aerial and press one of the buttons within 5 seconds of selecting the ISAT scan tool command.

Deprogramming all remote controls
1 Select "REMOTE CONTROL".
Select "DEPROGRAM ALL".
2 All programmed remote controls will then be deprogrammed.


Important: Make a habit of always having the ignition switch in the drive position when deprogramming all remote controls. This is to avoid deprogramming while the car is armed.
If a remote control is lost, all remote controls can be deprogrammed. This means that the customer must bring in all the remote controls for reprogramming.