Programming For Remote Control

The remote control that is used for the car theft alarm must be programmed (coded) for the particular car. When the car is delivered, 2 pre programmed remote controls are included. It is also possible to program a further two remote controls (a total of 4 remote controls can be programmed) for the car.

Programming
One remote control
1 Connect the Intelligent Saab Tester (ISAT) scan tool.
Select "PROGRAMMING".
2 Select "CONTROL".
Select "PROGRAMMING".
3 Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.

Deprogramming a remote control
1 Select "CONTROL".
Select "DEPROGRAMMING".
2 Point the remote control at the antenna and press on of the buttons within 5 seconds of selecting the ISAT scan tool command.

Deprogramming all remote controls
1 Select "CONTROL".
Select "DEPROGRAM ALL".
2 All programmed remote controls are then deprogrammed.


Important: Make a habit of always having the ignition in the drive position when deprogramming all remote controls. This is to avoid deprogramming while the car is armed.
If a remote control is lost, all remote controls can be deprogrammed. This means that the customer must take all remote controls for reprogramming.