In Vehicle

REPLACEMENT
1. Remove the drive shaft on the lefthand side and the drive shaft and intermediate shaft on the righthand side.
- Refer to Steering and Suspension.
2. Remove the five screws which hold the seal holder.
3. Carefully pry out the seal holder with two large screwdrivers.
- Put the shims in a safe place.
4. Replace the sealing ring and O-ring.
5. Install the shims and carefully tap in the seal holder.
- Tighten the screws to 20-24 Nm (14.5-17.5 ft. lbs.).
6. Install the drive shafts.