Ignition Switch - Contacts Binding

CATEGORY
Electrical

SECTION
3

PAGE
45

ISSUE
06/93-0355

CODE
364

Subject:
Binding Ignition Switch Contacts

Application:
900 Models

On Saab 900 models, it is possible to lose certain functions in the electrical system due to binding in the ignition lock mechanism.

If the lock mechanism binds, the ignition switch could remain in an intermediate position not returning all the way back to the Drive position after starting.

When the ignition switch is in this intermediate position the loss of some of the car's electrical system functions is possible.

Follow the instructions below to remedy this problem.

Cars Affected:

Saab 900 Models

Ignition Lock: Manual Transmission 82 83 798
Automatic Transmission 83 15 582

Ignition Switch All 900's 85 67 505





Action:

1. Remove the center console to access the ignition lock cylinder and switch mechanism. Refer to Service Manual 4:1 for more detailed instructions.

2. Lubricate the ignition lock cylinder and switch mechanism using ordinary motor oil. Adjust the lock cylinder, if necessary, according to Service Manual 4:1.

3. With the gear shift lever in neutral or park and the parking brake applied, operate the key to circulate the lubricant and to determine if the key continues to bind.

4. If the switch mechanism continues to bind or jam, replace the ignition switch with a new switch.

Warranty Information:

For warranty claims, use failure coding 43262-27-0-01-05. Time allowance is labor op. no. 43262 (1.8 hours) if manual transmission or op. no. 43221 (1.4 hours) if automatic transmission.