Tightening Specifications (Front)

TIGHTENING SPECIFICATIONS
Anti-Roll Bar Nut: 7
Axle Nut: 214
Ball Joint Nut: 55
Ball Joint, Steering Swivel Member: 75 Nm (55.4 ft. lbs.)
Clamping Bolts, Tie-Down Bracket: 24 Nm (17.7 ft. lbs.)
Damper: 159
Driveshaft Nut: 214
Front Swing Arm To Sub-Frame [1]: 115 Nm (84.9 ft. lbs.)
Hub Center Nut: 214
MacPherson Strut Top Mounting Retaining Nuts: 13
Rear Spring Link Mounting To Body [1]: 65 Nm (48 ft. lbs.)
Steering Arm To Subframe Bolt: 85
Support Arm To Suspension Arm Bolt: 68
Support Arm Mounting on Subframe: 100 Nm +75 to 90° (73.8 ft. lbs. +75 to 90°)
Support Arm Mounting on Suspension Arm: 92 Nm (67.9 ft. lbs.)
Support Mounting To Spring Link: 92 Nm (67.9 ft. lbs.)
Suspension Arm Mounting on Subframe [1]: 115 Nm (84.9 ft. lbs.)
Tie Rod To Steering Gear Bolts: 68
Wheel Bolts: 78-96

[1]: Tighten when all four wheels are on the ground.