Replacement

It may be necessary to clear the DTCs from the control module memory after component has been installed.
1. Disarm SRS as outlined under Air Bags (Supplemental Restraint Systems)/Service and Repair/Disarming and Arming.
2. Position front seat forward, then position the seat backrest forward.
3. Remove door sill plate.
4. Release bottom edge of seat belt guide cover, then remove guide cover.
5. Remove seat belt guide from B-pillar.
6. Remove seat belt guide from B-pillar, then remove trim panel.
7. Remove cover from seat belt pretensioner.
8. Disconnect connector at seat belt pretensioner.
9. Remove seat belt reel attaching bolts, then remove seat belt reel.
10. Reverse procedure to install, noting the following:
a. Tighten attaching bolts to specifications.