4:2 Automatic Transmission
Page 104-1 Special tools86 11 158 Test wiring should be 86 11 154 Test wiring.
Page 400-3 Technical description
Active components in various gear positions
In shift position D the table shows "ON" for S2 in 3rd and 4th gears. It should show "OFF".
Page 400-18 Technical description
Grounding points
The last line in the second paragraph should read: "...between pin 35 and the negative battery terminal."
Pages 400-19 and 400-20 Technical description
In the illustration the designations 532 and 533 are transposed. 533 should be 532 and 532 should be 533.
Page 400-40 Technical description
The last sentence under 6-cyl should read: "The above pulse duration corresponds to 0.9 ms to 9.2 ms."
Page 400-43 Technical description
Replace step 2 as follows:
2 Run the engine at idling speed. Engage position D and wait at least 15 seconds. Then engage position R and wait another 15 seconds. Do the same in position P.
Page 440-44 Fault-tracing
Diagnostic trouble code P1817 - Fault symptom
"Warning lamp CHECK ENGINE lit" should read "Warning lamp CHECK GEARBOX lit".
Page 440-80 Fault-tracing
Wiring diagram TCM
The designations 532 and 533 in the wiring diagram have been transposed. 533 should be 532 and 532 should be 533.