Antenna Amplifier: Service and Repair

Removing And Installing Antenna Amplifier, - As Of MY 2003







NOTE:
- The antenna amplifier is installed in connection with the PCM2.
- The antenna amplifiers are located on the A-pillars.

Removing antenna amplifier
- Remove the respective trim of the A-pillar.

1. Disconnect the antenna plugs for the windscreen -1- and -2-.







2. Disconnect the plug connections for the antenna control module -3, 4- left side, -3, 4, 5- right side.
3. Unscrew the two fastening screws -6-.

Installing antenna amplifier
1. Position the antenna amplifier on the A-pillar and screw the fastening screws -6- tight.







2. Connect the plug connections for the antenna control module -3, 4- left side, -3, 4, 5- right side.
3. Connect the antenna plugs for the windscreen -1- and -2-.
- Install the respective trim of the A-pillar.