6. Manual Shift Shaft Pin, Detent Lever, and Park Pawl Actuator Assembly Removal

Manual Shift Shaft Pin, Detent Lever, and Park Pawl Actuator Assembly Removal




1. Using needle-nose pliers, remove the manual valve lever shaft retainer spring.




2. Remove the bolts (1, 2) and manual shaft detent spring and plate.




3. Remove the bolts (1, 2) and parking lock pawl bracket.




4. Using a screwdriver and hammer, remove the manual shift detent lever spacer (1).




5. Using a pin punch and hammer, drive out the pin.
Slowly drive out the pin so that it will not fall into the transaxle case.




6. Remove the manual valve lever shaft, manual valve lever, and spacer.




7. Remove the parking lock rod sub-assembly from the manual valve lever sub-assembly.
Align the dial with the notches on the manual valve lever sub-assembly to remove the parking lock rod sub-assembly.




8. Using a screwdriver, remove the oil seal from the transaxle case.