C1201

DTC C1201

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C1201
- Throttle Control System Performance

Circuit/System Description

The electronic brake control module (EBCM) monitors the powertrain control module (PCM). The EBCM will prevent traction control and vehicle stability control (VSC) operation if it determines fault within the powertrain control system.

Conditions for Running the DTC

Engine speed is above 500 RPM

Conditions for Setting the DTC

The EBCM detects a fault within the powertrain control system.

Action Taken When the DTC Sets

* The traction control and VSC is disabled.
* The VSC warning indicator turns ON.

Conditions for Clearing the DTC

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, verify that DTC C1201 is only DTC set.

If other DTC is set, refer to appropriate DTC prior to diagnosing C1201.

If other DTC is not set, replace the powertrain control module (PCM).

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming