C0236

DTC C0226-C0256

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0226
- Right Front Solenoid Circuit Malfunction

DTC C0236
- Left Front Solenoid Circuit Malfunction

DTC C0246
- Right Rear Solenoid Circuit Malfunction

DTC C0256
- Left Rear Solenoid Circuit Malfunction

Circuit/System Description

The solenoid valves are part of the brake pressure modulator valve (BPMV). The BPMV turns ON and OFF the solenoid valves as deemed necessary to modulate hydraulic pressure to the wheel brakes during an ABS stop.

Conditions for Running the DTC

Ignition voltage is greater than 9.5 volts.

Conditions for Setting the DTC

The electronic brake control module (EBCM) detects one of the following conditions in the solenoid circuitry:

* An open
* A short to ground
* A short to voltage

Action Taken When the DTC Sets

* The ABS is disabled.
* The ABS warning indicator turns ON.

Conditions for Clearing the DTC

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, verify that DTC C0226, C0236, C0246 or C0256 is not set.

If DTC is set, replace the EBCM/BPMV.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming