Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replacement, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).
* Revise the yaw rate calibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.

Yaw Rate Sensor/Lateral Accelerometer Replacement

Note: Be sure the shift lever is in P (for automatic transaxle model) or in neutral and the parking brake is applied (for manual transaxle model).

If the yaw rate sensor/lateral accelerometer is replaced, the following procedures must be performed:

* Revise the yaw rate recalibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.