Camshaft Position Sensor Replacement - Exhaust

Camshaft Position Sensor Replacement - Exhaust

Removal Procedure




1. Disconnect the engine wiring harness electrical connector (4) from the exhaust camshaft position (CMP) sensor.




2. Remove the CMP sensor bolt. (Intake CMP shown, exhaust CMP similar)
3. Remove the CMP sensor.

Installation Procedure





Note: Inspect the CMP sensor for damage. Replace as necessary.

1. Lubricate the CMP sensor O-ring seal with clean engine oil.
2. Install the CMP sensor. (Intake CMP shown, exhaust CMP similar)
Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP sensor bolt and tighten to 10 Nm (89 lb in).




4. Connect the engine wiring harness electrical connector (4) to the exhaust CMP sensor.