Rear Split Folding Seat Back Replacement

Rear Split Folding Seat Back Replacement

Removal Procedure




1. Lower the rear seat backs.
2. Remove the bolts that secure the rear seat backs to the hinges.
3. Remove the rear seat backs by pulling the seat hinge posts out of the front wheelhouse trim.


Installation Procedure




1. Install the rear seatback by inserting the seat hinge posts into the front wheelhouse trim.

Notice: Refer to Fastener Notice (Fastener Notice).

2. Install the seat backs to the hinges with the bolts.

Tighten the seatback bolts to 25 N.m (18 lb ft).

3. Raise the rear seat backs in the upright position.