Tie Rod End: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

Tools Required

J-42188-B Ball Joint Separator

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.
3. Loosen, do not remove, the outer tie rod end stud nut (2) from the outer tie rod end ball stud.
4. Install J-42188-B between the steering knuckle and the outer tie rod end stud.
5. Tighten the nut on J-42188-B until the steering knuckle and the outer tie rod end stud separate.
6. Remove J-42188-B and the outer tie rod end stud nut.




7. Remove the outer tie rod end stud (5) from the steering knuckle (4).
8. Loosen the jam nut (2) on the inner tie rod assembly.
9. Remove the outer tie rod end (5) from the inner tie rod assembly (1).

Installation Procedure




1. Install the outer tie rod end (5) to the inner tie rod assembly (1). Do not tighten the jam nut.
2. Install the outer tie rod end stud (5) to the steering knuckle (4).

Notice: Refer to Fastener Notice.

3. Install the outer tie rod end stud nut (3) to the outer tie rod end stud (5).

Tighten to 30 N.m (22 lb ft) plus an additional 115�.

4. Install the tire and wheel assemblies.
5. Lower the vehicle.

Important: Do not twist the rack and pinion boot during toe adjustment.

6. Adjust the wheel toe. Refer to Front Toe Adjustment.