Folding Top Number 1 Bow Replacement

Folding Top Number 1 Bow Replacement

Removal Procedure





Important: The folding top will be required to be opened and supported.

1. Remove the left and right side front weatherstrips.

2. Remove the left and right side front weatherstrip retainers.
3. Open and support the folding top.
4. Remove the folding top cover No. 1 bow retainer.

Important: The folding top cover retainer flaps are glued to the front side rail and to the No. 1 bow.

5. Fold back the front and side edge of the folding top cover by releasing the retainer strips to expose the latch, springs and cables.
6. Remove the folding top front latch if required.
7. Disconnect the cables and springs from the No. 1 bow.
8. With the aid of an assistant, remove the screws (1) from the folding top No. 1 bow panel rear mounting point.
9. With the aid of an assistant, remove the folding top No. 1 bow panel (2) from midrear mounting point.

Installation Procedure




1. With the aid of an assistant, loose fit folding top No. 1 bow panel (2).
2. Position folding top No. 1 bow panel for best fit.
3. Close and latch the top.

Notice: Refer to Fastener Notice.

4. Tighten the screws (1) to the folding top No. 1 bow panel midrear mounting point.

Tighten the screws to 10 N.m (89 lb in).

5. Connect the cables and springs to the No. 1 bow.
6. Install the folding top front latch if required.

Important: The old adhesive must be removed and follow the manufacture directions for the new adhesive.

7. Reposition the front and side edge of the folding top cover retainer strips and glue into position.
8. Install the left and right side front weatherstrip retainers.
9. Install the left and right side front weatherstrips.
10. Install the folding top cover No. 1 bow retainer.
11. Inspect the folding top for proper fit and operation.