Trim Panel Replacement - Rear Door

TRIM PANEL REPLACEMENT - REAR DOOR

TOOLS REQUIRED
J 21104-B (KM 475-B) Weatherstrip Remover Universal

REMOVAL PROCEDURE




1. Lower the rear window.
2. Remove the rear window regulator handle.
3. Remove the door pull screw.
4. Remove the inside door handle.




5. Remove the rear door interior garnish molding.
6. Remove the screws at the base of the trim panel.
7. Pry off the trim panel using the trim remover J 21104-B (1).

INSTALLATION PROCEDURE




1. Install the trim panel.
2. Install the screws at the base of the trim panel.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the trim panel screws to 3.5 N.m (31 lb in).




3. Install the rear door interior garnish molding.
4. Install the inside door handle.
5. Install the door pull screw.

Tighten the door pull screw to 3.5 N.m (31 lb in).

6. Install the rear window regulator handle.
7. Raise the window.