Defroster Actuator

DEFROSTER ACTUATOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel cluster (IPC).
2. Lower the instrument panel (I/P) lower trim panel assembly.
3. Remove the clip (1), spacers (2) and actuator rod (4) from the lever (3).
4. Disconnect the vacuum line (6) from the actuator (5).
5. Remove the retaining screws (7) from the actuator.
6. Remove the actuator from the HVAC unit.

INSTALLATION PROCEDURE




1. Install the actuator (5) to the HVAC unit.
2. Secure the actuator to the HVAC unit with the retaining screws (7).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 4 N.m (35 lb in).

3. Connect the vacuum line (6) to the actuator.
4. Install the clip (1), spacers (2) and actuator rod (4) to the lever (3).
5. Install the I/P lower trim panel assembly.
6. Install the IPC.