Lifter / Lash Adjuster: Service and Repair

Valve Lifter Replacement

Tools Required
^ J3049-A Valve Lifter Remover

Removal Procedure
1. Remove the cylinder head.





2. Remove the guide bolts (211).
3. Remove the guides (210) with lifters. Note the installed position of the guides. The notched area of the guide is to align with the locating tab on the block.





4. Remove the valve lifters (209) from the guide (210).
5. Organize or mark the components so they can be installed in the same location from which they were removed. Refer to Separating Parts.

Installation Procedure





1. Important:
^ When using the valve lifters again, install the lifters to their original locations.
^ If camshaft replacement is required, the valve lifters must also be replaced.

Lubricate the valve lifters (209) and engine block valve lifter bores with clean engine oil.
2. Insert the valve lifters into the lifter guides (210). Align the flat area on the top of the lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.





3. Install the valve lifters and guide assembly (210) to the engine block.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the valve lifter guide bolts (211).
Tighten the valve lifter guide bolts to 10 Nm (89 inch lbs.).
5. Install the cylinder head.