Fascia Extension Replacement - Front

Fascia Extension Replacement - Front

Tools Required

J 41409 Body Molding Removal Tool


Removal Procedure

1. Raise and support vehicle. Refer to Lifting and Jacking the Vehicle in General Information.




2. Remove the license bracket. Refer to License Bracket Replacement - Front (Service and Repair) .
3. Remove the push-in retainers from the front lower fascia.
4. Remove the screws from the front lower wheel arch opening.
5. Apply masking tape to the front fascia border of the extension, to protect the front fascia from scratches. The tape will also aid in aligning the extension during installation.

Important: Do not overheat the component.


6. Using an auxiliary heat source, heat the front fascia lower extension to between 40-60°C (104-140°F).
7. Use J 41409 or the equivalent in order to cut through the adhesive material.
8. Remove the front fascia extension from the vehicle.



Installation Procedure


Important: Apply the adhesive tape in an environment free of dust or dirt so that it does not come in contact with the sticky backing and prevent proper adhesion.


1. Clean the area where the front fascia extension is to be mounted.
2. Use a suitable solvent, such as a mixture of 50 percent isopropyl alcohol and 50 percent water, or equivalent.
3. Dry the area thoroughly.




4. Install adhesive tape to the outside edges of the front bumper fascia extension.
5. Ensure that the body area is at a temperature range of 20-30°C (68-86°F). Heat the area, if necessary.
6. Peel back 25.0 mm of the tape liner from both ends.
7. Align front bumper fascia extension to the front bumper fascia.
8. Carefully remove the tape liner starting from the center of the vehicle and press down working from the center to get good adhesion. Keep a distance of 6 inches between pressing down on tape area onto vehicle and peeling of tape liner to avoid stretching liner resulting in the liner breaking.
9. using a roller, apply pressure to the part to press the tape onto the fasica.





Notice: Refer to Fastener Notice in Cautions and Notices.

10. Install the screws to the front lower wheel arch opening.

Tighten the screws to 2 N.m (17 lb in).

11. Fasten the lower edge of the front fascia extension using the push-in retainers.
12. Install the license bracket. Refer to License Bracket Replacement - Front (Service and Repair) .
13. Lower vehicle.