Four-Door

REMOVAL PROCEDURE
1. Remove the rear seat cushion.
2. Remove the lower anchor bolt that retains the seat belt (2).
3. Remove the following components that retain the guide loop (1) of the rear seat belt:
^ The plastic cover
^ The anchor bolt
^ The washers
^ The spacer
4. Remove the lower rear seat.
5. Remove the 3 plastic retainer clips from the rear back seat side trim. Gently position the rear back seat side trim so that the seat belt (2) can be fed through the opening to the rear compartment.
6. Feed the seat belt (2) through the opening.
7. Open the rear compartment lid.
8. Reposition the rear compartment interior trim in order to gain access to the rear seat belt retractor (4).
9. Remove the mounting bolt and the rear seat bell retractor (4) from the vehicle.

INSTALLATION PROCEDURE
1. Feed the seat belt (2) through the opening.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the rear seat belt retractor (4) to the vehicle. Secure the retractor with the mounting bolt.

Tighten
Tighten the seat belt retractor bolt to 45 N.m (33 lb ft).

3. Install the guide loop (1) of the rear seat belt to the vehicle. Secure the guide loop with the following fasteners:
- The anchor bolt
- The washers
- The spacer
- The plastic cover

Tighten
Tighten the guide loop anchor bolt to 45 N.m (33 lb ft).

4. Reposition the rear seat side trim around the seat belt. Secure the side trim with the 3 plastic retainer clips.
Raise the rear seat.
5. Install the rear seat belt (2) to the vehicle. Secure the belt with the lower anchor bolt.

Tighten
Tighten the rear seat belt bolt to 45 N.m (33 lb ft).

6. Install the rear seat belt buckle (3) to the vehicle. Secure the buckle with the anchor bolt.

Tighten
Tighten the seat belt buckle bolt to 45 N.m (33 lb ft).

7. Install the rear seat cushion.