Engine Mount Replacement (Rear Engine Mount)

Removal Procedure

^ Tools Required
- J 28467-A Universal Support Fixture
- J 28467-89 Engine Support Fixture Adapters (Metro)

1. Use a J 28467-A with a J 28467-89 in order to support the engine. Refer to Engine Support Fixture.
2. Remove the rear engine mount through-bolt and nut from the rear engine mount.
3. Remove the two rear engine mount-to-bulkhead bolts.
4. Remove the rear engine mount from the upper rear mounting bracket.





5. Remove the two retaining nuts and the upper rear mounting bracket from the lower rear mounting bracket (6).
6. Remove the three retaining bolts and the lower bracket (6) from the vehicle.

Installation Procedure

^ Tools Required
- J 28467-A Universal Support Fixture
- J 28467-89 Engine Support Fixture Adapters (Metro)





1. Install the lower rear mounting bracket (6) to the vehicle.
2. Secure the mounting bracket (6) with the three retaining bolts.

Notice: Refer to Fastener Notice in Service Precautions.

Tighten the mounting bracket retaining bolts to 55 Nm (41 ft. lbs.).
3. Install the upper rear mounting bracket to the lower rear mounting bracket (6).
4. Secure the mounting brackets with the two retaining nuts. Do not tighten fully.
5. Install the rear engine mount to the upper rear mounting bracket.
6. Secure the rear engine mount with the two rear engine mount-to-bulkhead bolts. Do not tighten fully.
7. Install the rear engine mount through-bolt to the rear engine mount.
8. Secure a nut on the through-bolt.
^ The rear engine mount through-bolt and nut to 55 Nm (41 ft. lbs.).
^ The rear engine mount-to-bulkhead bolts to 55 Nm (41 ft. lbs.).
^ The upper rear mounting bracket retaining bolts and nuts to 55 Nm (41 ft. lbs.). Remove the J 28467-A and the J 28467-89.