Brake Modulator Bracket Replacement

Removal Procedure

Caution: To help avoid personal injury, due to a retained load on the brake modulator, the Gear Tension Relief function of the scan tool must be performed prior to removal of the ABS brake modulator assembly.





1. Remove the hydraulic modulator assembly. Refer to Brake Modulator Assembly Replacement.
2. Remove the bracket mounting bolts (4).
3. Remove the bracket from the subframe.

Installation Procedure





1. Install the bracket onto the subframe.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install mounting bolts (4).
- Tighten the bracket mounting bolts to 25 Nm (18 ft. lbs.).
3. Install the hydraulic modulator assembly. Refer to Brake Modulator Assembly Replacement.