Control Assembly Bulb Replacement
Control Assembly Bulb ReplacementREMOVAL PROCEDURE
1. Remove the center console trim bezel.
2. Remove the radio.
3. Grasp firmly on the heater control unit lever knobs in order to pull the knobs out.
4. Remove the 1 screw retaining the right side instrument panel (IP) cluster lower cover.
5. Remove the right side IP cluster lower cover.
6. Gently pry out the heater face plate.
7. Remove the bulb from the lamp socket.
INSTALLATION PROCEDURE
1. Install the bulb to the lamp socket.
2. Install the IP cluster lower cover. Secure the cover with the 1 screw.
3. Install the heater control unit lever knobs.
4. Install the radio.
5. Install the center console trim bezel.