Sunroof / Moonroof Panel: Adjustments

SUNROOF GLASS HEIGHT ADJUSTMENT

FLUSHNESS
1. Position sunshade in full rearward position.
2. To adjust front of glass:
a. Loosen front and middle glass attachment screws
b. Adjust front of sunroof glass panel so that the corners are flush to 1.0 mm below the top surface of the roof panel.
c. Tighten all glass attachment screws.
3. To adjust rear of glass:
a. Loosen rear and middle glass attachment screws
b. Adjust rear of sunroof glass panel so that the corners are flush to ± 1.0 mm off the top surface of the roof panel.
c. Tighten all glass attachment screws,

VENT HEIGHT
1. Cycle the sunroof module to vent position using the drive motor.
2. Check glass height in tilt using the appropriate measuring tool,
3. If the vent height is greater than 35 mm, using switch slowly set to correct height.
4. After setting correct height, remove drive motor.
5. With the motor removed, use the switch to set tilt by operating the gear to the full closed position.
6. Using tilt switch only, operate the motor until it comes to a full stop at tilt position.
7. Install drive motor and verify correct operation.