Installation

CAUTION: When installing interlock cable assembly, care must be taken not to bend exposed cable wire and slug at shifter end of cable.

1. Route interlock cable into lower dash panel.
2. Install the ignition switch into housing. Turn the ignition switch to the RUN position.





3. Install the interlock cable into the interlock housing at the steering column. Verify the cable snaps into the housing.
4. Install interlock cable into routing clip located within the wiring harness.
5. Route interlock cable to the console.
6. Install the cable core end to the plastic cam of the shifter mechanism. Snap the shifter/ignition interlock cable end fitting into the groove in the gearshift mechanism.
7. Adjust the Shifter/Ignition Interlock System.
8. Perform the Shifter/Ignition Interlock System operation check.
9. Install console assembly.
10. Install screws retaining the gearshift indicator bezel and install bezel and indicator lamp.
11. Install the gearshift knob set screw and knob.
12. Install two screws at the upper area of the column liner and lower left corner.
13. Snap the clips in at the lower column cover. Install the three screws along the bottom of the lower steering column cover and screw on the left outward face of cover.
14. Install key cylinder.
15. Position the shrouds in place. Install the three lower-to-upper shroud attaching screws through the bottom of the lower shroud.
16. Reinstall the ignition lock cylinder into housing.
17. Reconnect the battery negative (-) cable to the vehicle battery.