Dash Integration Module Replacement
DASH INTEGRATION MODULE REPLACEMENTREMOVAL PROCEDURE
1. Before replacing the Dash Integration Module (DIM), record the personaization settings to transfer to the new module (if they are available).
2. Remove the right closeout/ insulator panel.
3. Remove the DIM from the bracket by releasing the tab behind the module.
4. Disconnect the electrical connectors (1) from the DIM (2).
INSTALLATION PROCEDURE
1. Connect the electrical connectors (1) to the DIM (2).
2. Install the Dash Integration Module (DIM) into the bracket.
3. Install the right closeout/insulator panel.
4. Reprogram the DIM. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM). Programming and Relearning