Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONSAmbient Light Sensor: Displays volts. The sunload sensor assembly signal, 0.09-4.75 volts is the normal operating range.
Battery Voltage: Displays 0-20 volts. The voltage as received on the battery positive voltage circuit of the module.
Control Power: Displays On/Off. The state of control power.
Daytime Running Lamp: Displays On/Off. The commanded state of the daytime running lamp relay.
Driver Door Jamb Sw: Displays On/Off. The state of the drivers door jamb switch. On indicates the door is open and Off indicates the door is closed.
Flash to Pass Switch: Displays On/Off. The state of the flash to pass switch.
Front Fog Lamp Relay: Displays On/Off. The commanded state of the front fog lamp relay.
Front Fog Lamp Switch: Displays On/Off. The state of the front fog lamp switch.
Headlamp Switch: Displays On/Off. The state of the headlamp switch. On indicates the headlamps are requested on.
High Beam - Flash to Pa: Displays On/Off. The commanded state of the high beam relay.
Inadvertent Power Input: Displays On/Off. The state of the inadvertent power.
Inadvertent Power Relay: Displays On/Off. The commanded state of the inadvertent power relay.
Incandescent Dim 1: Displays 0-100%. The percentage of dimming sent to the incandescent lamps.
Interior Dim Pot: Displays 0-5.0 volts. The IP dimmer switch input signal, 0.09-4.75 volts is the normal operating range.
Interior Lamp Switch: Displays OFF/DOOR/ON. The position of the interior lamp switch.
Left Rear Door Jamb Sw: Displays On/Off. The state of the left rear door jamb switch. On indicates the door is open and Off indicates the door is closed.
Lights On with Wipers: Displays On/Off. The state of the wiper/washer system.
Low Beam Output: Displays On/Off. The commanded state of the low beam relay.
Lt. Turning Signal Sw: Displays On/Off. The state of the left turn signal switch.
Non-Overhead Lamps Relay: Displays On/Off. The commanded state of the non-overhead lamps relay.
Overhead Lamps Output: Displays On/Off. The commanded state of the overhead lamps.
Pass. Door Jamb Sw: Displays On/Off. The state of the right front door jamb switch. On indicates the door is open and Off indicates the door is closed.
Park Lamp: Displays On/Off. The state of the park lamp switch.
Park Lamp Relay Output: Displays On/Off. The commanded state of the park lamp relay.
Rear Fog Lamp Relay: Displays On/Off. The commanded state of the rear fog lamp relay.
Rear Fog Lamp Switch: Displays On/Off. The state of the rear fog lamp switch.
Rt. Rear Door Jamb Sw: Displays On/Off. The state of the right rear door jamb switch. On indicates the door is open and Off indicates the door is closed.
Rt. Turning Signal Sw: Displays On/Off. The state of the right turn signal switch.
Reverse Lamp Relay: Displays On/Off. The commanded state of the reverse lamp relay.
Twilight Delay Pot: Displays volts. The twilight delay switch input signal, 0.09-5.0 volts is the normal operating range.