Heater Pipe Replacement - Inlet
HEATER PIPE REPLACEMENT - INLETTOOLS REQUIRED
J 38185 Hose Clamp Pliers
REMOVAL PROCEDURE
1. Drain the cooling system.
2. Remove the air cleaner assembly.
3. Using the J 38185 loosen the heater inlet hose clamp.
4. Remove hose from the heater pipe (2).
5. Remove the inlet pipe (2) nut from the transaxle.
6. Squeeze the quick connect release tabs (1) on the inlet pipe and pull out on the inlet heater pipe to remove.
INSTALLATION PROCEDURE
1. Install the inlet pipe (2) into the adapter (3) by pushing together. Pull back to ensure a good connection.
2. Position the inlet pipe (2) on the transaxle stud and install the nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 24 N.m (18 lb ft).
3. Install the heater inlet hose (2) to the heater pipe.
4. Using the J 38185 reposition the clamp.
5. Install the air cleaner assembly.
6. Fill the cooling system.