Heater Pipe Replacement - Outlet
HEATER PIPE REPLACEMENT - OUTLETTOOLS REQUIRED
J 38185 Hose Clamp Pliers
REMOVAL PROCEDURE
1. Drain the cooling system.
2. Remove the air cleaner assembly.
3. Using the J 38185 loosen the heater outlet hose clamp.
4. Remove the hose (1) from the heater pipe.
5. Remove the outlet pipe (1) nut from the transaxle.
6. Using the J 38185 loosen the clamp from the back side of the thermostat housing.
7. Remove the outlet pipe assembly (1).
INSTALLATION PROCEDURE
1. Install the outlet pipe assembly (1) to the thermostat housing and reposition the clamp.
2. Position the outlet pipe (1) on the transaxle stud.
3. Install the nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 24 N.m (18 lb ft).
4. Install the heater outlet hose (1) to the heater pipe.
5. Using the J 38185 reposition the clamp.
6. Install the air cleaner assembly.
7. Fill the cooling system.