Tire Pressure Monitor (TPM) - Reset (Calibrate)

RESET CHECK TIRE PRESSURE SYSTEM
Don't reset the check tire pressure system without first correcting the cause of the problem and checking and adjusting the pressure in all four tires. If you reset the system when the tire pressures are incorrect, the check tire pressure system will not work properly and may not alert you when a tire is low or high.

To reset (calibrate) the system:
1. Turn the ignition switch to ON.
2. Press the SELECT right arrow on the Driver Information Center (DIC) until you enter the GAGE mode. Then press the SELECT down arrow until TIRE PRESSURE appears on the display.
3. Press and hold the DIC RESET button for about five seconds. After five seconds, the display will show "TIRE PRESSURE RESET". If "TIRE PRESSURE RESET" does not appear on the display after about five seconds, see your dealer for service. After you release the DIC RESET button, "TIRE PRESSURE NORMAL" will appear on DIC display.

The system completes the calibration process during driving. Calibration time can take 45 to 90 minutes, depending on your driving habits. After the system has been calibrated, the system will alert the driver that a tire is low, up to a maximum speed of 65 mph (105 km/h).