Scan Tool Data Definitions - ALC

Scan Tool Data Definitions
Accum Fault-Compressor: Defined period of time the compressor is active with out an exhaust cycle.
ALC Compressor Active: Indicates when the compressor is running.
ALC Exhaust Solenoid Active: Indicates when the exhaust solenoid is on.
ALC Relearn: This procedure reprograms the RIM with the ride height specification, per the suspension option.
Battery Low-Compressor: This indicates when there is low voltage at compressor.
Calibration I.D.: This number designates the modules calibration.
Exhaust: Defined period of time that the exhaust is active with out a compressor cycle.
Filtered Position Valve: As the vehicle operates the suspension position sensor is monitored, and the information is filtered, to the RIM so it can adjust the suspension.
Leveling Sensor Feed: Voltage feed to the suspension position sensor.
Progress Fault-Compressor: Defined period of time that the compressor is active, and a change is not detected by the sensor.
Progress Fault-Exhaust: Defined period of time that the exhaust is active and no change is detected at the sensor.
Prom I.D.: The modules internal "PROM" identifier.
Suspension Position Sensor: Indicates the sensor signal voltage to the control module.
Trim Value: A value programmed in the RIM