Air Cleaner Fresh Air Duct/Hose: Service and Repair
AIR CLEANER INTAKE DUCT REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the Mass Air Flow/Intake Air Temperature (MAF/IAT) sensor electrical connector.
2. Loosen the air cleaner intake and MAF/IAT assembly clamps from the throttle body side and from the air cleaner cover side.
3. Remove the air cleaner intake and MAF/IAT assembly from the vehicle.
4. Separate the air cleaner intake duct from the MAF/IAT sensor.
INSTALLATION PROCEDURE
1. Combine the air cleaner intake duct and the mass air flow/intake air temperature (MAF/IAT) sensor.
2. Install the air cleaner intake and the MAF/IAT assembly on the throttle body and on the air cleaner cover.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Inspect for proper alignment of the air cleaner intake and MAF/IAT assembly and tighten the hose clamps.
Tighten
Tighten the air cleaner intake and MAF/IAT assembly clamps to 3 N.m (27 lb in).
4. Connect the mass air flow/intake air temperature (MAF/IAT) sensor electrical connector.