Memory Positioning Module: Service and Repair

MEMORY SEAT CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Handling Caution in Service Precautions.




1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the fasteners securing the seat cushion to the adjuster track.
3. Lift the front of the seat cushion up in order to gain access to the memory seat module.

NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.

4. Disconnect the electrical connectors from the memory seat module.
5. Remove the fasteners securing the memory seat module to the seat cushion frame.
6. Remove the memory seat module from the bottom of the seat cushion.

INSTALLATION PROCEDURE




1. Position the memory seat module to the bottom of the seat cushion.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the memory seat module fasteners.

Tighten
Tighten the fasteners to 2 N.m (18 lb in).

3. Install the electrical connectors to the memory seat module.
4. Ensure the wiring harness is positioned in the same location in which it was removed.
5. Install the seat cushion.
6. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.