Case Extension Axle Seal (Right) Replacement

Case Extension Axle Seal (Right) Replacement

^ Tools Required
- J39051-1 Axle Shaft Seal Installer Set

Removal Procedure





1. Remove the right drive axle.

Important Be careful not to damage the transmission case extension when removing the seal with a screwdriver.

2. Remove the drive axle seal (125). First use a screwdriver to pry outer the seal from the transmission. Use pliers in order to remove the remaining housing of drive axle seal from the transmission.
3. Inspect the drive axle seal mating surface on the drive axle housing for corrosion, grooves or nicks.
4. Clean the drive axle seal mating surface on the drive axle housing with crocus cloth.

Installation Procedure

Important Be careful not to damage the transmission case extension when installing the drive axle seal.





1. Install the right-hand drive axle seal (125) using the J39051-1
2. Install the drive axle.