Turn Signal & Multifunction Switch - Assemble

ASSEMBLY PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.





1. Install the turn signal and multifunction switch assembly (2) and secure by using 2 pan head tapping screws (1).
- Tighten the screws to 7 Nm (62 inch lbs.).
2. Route the wire harness assembly (1) along the steering column jacket assembly.





3. Pop the wire harness assembly (1) into the wire harness strap (2).





4. Install 1 wire harness strap (2) to the upper tilt head assembly (1).
5. Install 1 wire harness strap (2) onto the wire harness assembly.
6. Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble -Off Vehicle.