Fuel Tank Pressure Sensor: Service and Repair

FUEL TANK PRESSURE SENSOR REPLACEMENT


REMOVAL PROCEDURE





CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the spare tire cover, the jack, and the spare tire.
3. Remove the trunk liner.
4. Remove the nuts (7) retaining the fuel sender access panel.
5. Remove the fuel sender access panel.




6. Disconnect the electrical connector from the fuel tank vapor pressure sensor.
7. Remove the fuel tank vapor pressure sensor (7) from modular fuel sender assembly.

INSTALLATION PROCEDURE




1. Install the new fuel tank vapor pressure sensor (7) to the modular fuel sender.
2. Connect the electrical connector to the fuel tank vapor pressure sensor




3. Reinstall the fuel sender access panel.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Reinstall the nuts (7) that retain the fuel sender access panel.

Tighten
Tighten the nuts to 10 N.m (8 lb ft)

5. Reinstall the trunk liner.
6. Reinstall the spare tire, the jack, and the spare tire cover.
7. Connect the negative battery cable.